Axxess-interface ASWC Manual do Utilizador descarregar pdf (Página 7)

Section 1: Installation

4) IfyouareusinganEclipse,Kenwood,MetraOE,oranewerJVC

radio,plugtheincludedfemale3.5mmconnectorwiththeBrown

andBrown/Whitewiresintothemale3.5mmconnectorofthe

ASWCharness.

•  For Kenwood and select JVC: ConnecttheSWCwire(normally

Blue/Yellow)totheBrownwireoftheASWC.Isolateandtape

theBrown/Whitewire,itwillnotbeused.

Note: Some newer Kenwood radios will auto detect as a JVC. If

this is the case, you can use a 12k-ohm resistor (included) in line

between the Blue/Yellow and Brown wire of the female 3.5 mm

jack during programming only. Or you can manually set the radio

type which is in the radio programming section of this manual.

•  For Eclipse:ConnecttheEclipseSWCwires(normallyBrown

andBrown/Black)totheBrownandBrown/Whitewiresofthe

ASWC. BrowngoestoBrownandBrown/WhitegoestoBrown/

Black.Sometimesthisisreversed,reversethewiresifneeded.

•  For Metra OE: ConnecttheSWCKey1wire(Gray)totheBrown

wireoftheASWC.

5) Forallotherradios,pluginthemale3.5mmconnectoroftheASWC

intothebackoftheaftermarketradio,designatedforanexternal

SWCcontrolinterface.Ifindoubtwherethe3.5mmconnectorof

theASWCgoespleaserefertotheaftermarketradiomanual.Once

allconnectionshavebeenmade,plugintheaftermarketradioifnot

donealready.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sem comentários

Axxess-interface ASWC Manual do Utilizador Página 7